MEDITECH Reports

[MEDITECH-L] Evaluate if a Pharmacy Fragment Returns a Value

Tweet

 

=== QUESTION ===
I have a MEDITECH report that calls a Pharmacy fragment report in a LC on HK7.  Sometimes the Fragment returns a value and sometimes not.  On my main report I want to count how many times a value is returned and how many times not. Here is the LC from the main report:

LC=@acct.number.display%5E/R.FRAG.ARG.1,
LC=%Z.rw.fragment("PHA.RX.zcus.sh.R","PHA.JOB"),1

Any suggestions ???

Terry

=== ANSWER ===
As you know, NPR fragments do not clean up the /R.FRAG.VAL.xx variables after fragments run. Which is why the /R.FRAG.VAL.xx structures are used to return your data. Here is one strategy that might work for you:

Set this value: 0^/R.FRAG.VAL.RESULT at the beginning of the fragment: at the top of your macro or another suitable place like a line attribute, footnote or custom field.

If the fragment has data to return, set this value: 1^/R.FRAG.VAL.RESULT near the end of the fragment: near the bottom of the macro that gets your data or another suitable place like a line attribute, footnote or custom field.

Extend your HK7 line check to calculate the total:

LC=@acct.number.display%5E/R.FRAG.ARG.1,
LC=%Z.rw.fragment("PHA.RX.zcus.sh.R","PHA.JOB"),
LC=/R.FRAG.VAL.RESULT+/HK7.TOTAL^/HK7.TOTAL,1

Depending on your report's setup; you could define an xx.total field and set VAL=/HL7.TOTAL.

John

Want an alert when the next post is published? Click the phone and Subscribe to the MEDITECH Reports Blog!